PART I - Engineeing (Civil)
1.
The Centre of Gravity of a triangle lies at the point of
2.
By compacting the soil we improve
3.
Live load on roof and floors are considered as
4.
Maximum bending moment about the face of the column is one of the consideration to determine
5.
The space of the wall between facing and backing is known as
6.
Bottom surface of a window opening is known as
7.
The tool used by masons for spreading mortar
8.
Bricks are obtained by molding
9.
A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m². The maximum height of wall from stability consideration is
10.
The brick bond which shows alternate courses of header and stretchers is known as
11.
In building construction D.P.C. stands for
12.
A number of forces acting at a point will be in equilibrium if
13.
Beam like horizontal structural flexural member, used to span over the opening of doors, windows is known as
14.
The splayed surface prepared on the top of an abutment or pier to receive the arch is known as
15.
Consider the following statements:
The use of relatively weak mortar
1. will accommodate movements due to loads and cracking if any, and will be distributed as thin hair cracks which are less noticeable or harmful.
2. will result in reduction of stresses due to differential expansion of masonry units.
The use of relatively weak mortar
1. will accommodate movements due to loads and cracking if any, and will be distributed as thin hair cracks which are less noticeable or harmful.
2. will result in reduction of stresses due to differential expansion of masonry units.
16.
Rapid hardening cement is suitable for
17.
If 'H' is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective ofthe direction of span will be
18.
Bulking of sand means, increase in its
19.
Fineness modulus of medium sand varies in between
20.
Nominal mix concrete of M20 grade contains cement, sand, coarse aggregate in the ratio of
21.
The effective length of R.C.C. column which is effectively held in position at both ends, restrained against rotation at one end will be
22.
Outside vertical members of framework of a shutter are known as
23.
Raft foundation is a type of
24.
For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for buildings constructed in
25.
The process by which timber is made sap free
26.
The process of joining two wooden pieces at an angle is known as
27.
The joint which is adopted when a timber piece is to be placed between two members which are previously fixed is known as
28.
This type of floor is mostly suitable or is used in kutcha village house
29.
The ridge formed by the intersection of two sloping surfaces having an exterior angle greater than 180° is known as
30.
A 200mm thick wall made of modular bricks is 5m long between cross walls and 3-8m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is
31.
When two forces, each equal to P, act at 90° to each other, then the resultant will be
32.
For compaction of soil we use
33.
Burnt clay bricks are generally classified in
34.
In normal circumstances where ordinary Portland cementis used, removal of form work for props to slab, spanning upto 4.5 m is done after
35.
Moist curing for concrete made of ordinary Portland cement and placed under normal condition is done for at least
36.
For underwater concreting cement content as per code shall be at least
37.
Earthquake forces are calculated as per IS code
38.
In G+4 building, the 'G' stands for
39.
Fittings that are placed at the ends of soil pipes or sullage pipes to prevent the passage of foul gases from the pipes to outside is known as
40.
The portion of structure which transfer load to the soil is known as
41.
For the purpose of determining the seismic forces, India has been classified into how many zones?
42.
In bathroom and W.C., the term W.C. stands for
43.
Deriving the maximum benefit from minimum dimension of the room without cramping of the plan, is known as
44.
For orientation of building in West Bengal best orientation is considered to be along east and west facing which direction?
45.
One kilo Pascal is equivalent to
46.
The unit of kinematic viscosity is
47.
Fora well conditioned triangle no angle should be less than
48.
A metallic tape is made of
49.
To measure distance we use
50.
Agonic line is the line joining points having
51.
A series of closely spaced contour lines represent a
52.
Which of the following methods of plane table surveying is used to locate the position ofan inaccessible point?
53.
The maximum permissible eccentricity for no tension at the base of a gravity dam is
54.
Which ofthe following represent hardest grade of bitumen?
55.
The treatment of water is done by adding
56.
Standard BOD is measured at
57.
Which of the following solid waste disposal method is ecologically most acceptable?
58.
Which of the following is the weakness of the BAR chart?
59.
A fully saturated soil is said to be
60.
Inorganic soils with low compressibility are represented by
61.
Sensitivity of soil can be defined as
62.
After storage, the strength of cement
63.
In R.C.C. beam side reinforcement is provided if its depth exceeds
64.
For treatment of sewage we use
65.
Size of right angled fillet weld is given by
PART II - English
66.
Choose the appropriate collective noun for the given sentence: A group of birds
67.
Apply suitable adjectives: Lipika is ----- than Latika.
68.
Apply suitable adjectives: Which is the ----- continent?
69.
Choose the correct phrasal verb: The price of petrol has increased.
70.
Choose the correct phrasal verb: Stop the fan.
71.
Nearest meaning of 'Maiden' is
72.
Give the simple past form of the verb 'Be'.
73.
He ----- till today.
74.
Perhaps he ----- here tomorrow.
75.
Choose the correct form of negative present perfect continuous tense from the given alternatives.
76.
Soma lives ----- a village. (Insert appropriate preposition)
77.
Father said to me, "Go home at once".
78.
The child said, "what a beautiful sight!"
PART III - General Knowledge
79.
The Chairman of the Rajya Sabha is
80.
At which of the following places, the Pole Star appears at the highest angle in the sky?
81.
In recently released Global Innovation Index (GII) 2018, India was ranked
82.
Tennis player Andy Murray belongs to which country?
83.
Lassa fever which was recently in news occurs in
84.
Who was recently appointed as Head of Mission and Chief Military Observer for UN Military Observer Group in India and Pakistan (UNMOGIP)?
85.
In which year, Kanyashree Prakalpa was launched?